As expected, I could not pull the splice apart with the car. It is almost certainly not necessary for the splice to be reliable, but it supplies lots of friction. Many people think the tapered part of the core contributes little or nothing to the strength of the splice. Tips and demonstration on how to make a locked brummel eye splice in braided line such as amsteel first with an existing eye splice in the opposite end and s. I did one other pull test, this one on a splice made with just the tapered part of the core, ie., the stretch from A to the end. The splice survived several seconds of hard, steady pull and then pulled apart-my very first experience of a splice pulling apart! ![]() Carefully I reduced the bury to exactly 1.5 inches. A hard steady pull with the car again left the splice unfazed. I carefully pulled out exactly 1 inch of core, leaving 2 inches of bury, as shown in the picture. Wow! This was considerably better than I expected. With a 3-inch bury, the splice didn't budge. As the picture indicates, the manufacturer-specified length of bury is 16 inches, 8 of which is tapered. Tip: Before beginning the splice, tape & cut the bitter end. In the picture above, the spliced eye has a very short buried section and no taper at all. A Locked Brummell Splice may be made, using only one end of the rope, in most Hollow Braid ropes. The pliability of Tenex TEC makes it good for eye-and-eye split tails, but it is also widely used for whoopies, loopies, continuous loops, what have you. Ordinary Tenex is not as pliable and it is not quite as roomy in the center. In the photo below, the pink rope is Tenex TEC and the yellow rope is ordinary Tenex. The "TEC" stands for Two End Carrier, which means each strand consists of two yarns. We will make an eye splice in 3/8 in Tenex TEC, or so-called "sling grade" Tenex, the 12-strand hollow braid polyester rope made by Samson. The pro, of course, will have made 10 of them by the time you finish your first, but yours should be just as strong. Just as a beginner can tie a bowline that is as reliable and pretty as any tied by a pro, a beginner's first splice, carefully made, will be as reliable as any made by a pro. Otherwise you will be prompted again when opening a new browser window or new a tab. ![]() The idea of this short photo tutorial is to demystify the procedures for probably the simplest of all splices and maybe prod a few people to give it a try. Check to enable permanent hiding of message bar and refuse all cookies if you do not opt in. My guess is the vast majority of people, even here on AS, have never spliced a rope until a couple of years ago I was among them. Compared to the vast amount of discussion on ArboristSite about knots, very little is said about splicing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |